How to make stupid hair easily and freely? Stupid hair stick

　Good afternoon. This time, we would like to thank all of you for your I have been receiving requests from you all for a long time. How to Make Stupid Hair! Looking for a simple and easy way to make it. After much trial and error We are pleased to finally introduce This time, MB01 is used. Even after it dries, it can be processed into various shapes. You can apply it as much as you like! VO I've been asked to show you how to make ahog hair." We have received a lot of requests from people who want to know how to make ahair. We all know by now that we use wire, and I was just thinking about it. Finally, I found a simple way to make ahogami. o(≧▽≦)o And it's a way that doesn't make the hair flow unnaturally! All you need is Hair bundles (cut hair is also acceptable), quick-drying bond, and vinyl ties. Use vinyl ties (color ties) instead of wire. You can find them at a home improvement center where they sell gardening supplies and tie ties. For thicker hair, 4 mm wide ties are convenient. If you feel it is too thick, cut the ratio wing (vinyl part) of the vinyl tie and If you feel it is too thick, you can cut the ratio wing (vinyl part) of the vinyl tape and use it narrower (ω・・・) First, cut the hair bundles and vinyl ties. (The bundle of hair used this time is about 5 cm wide.) Next, apply quick-drying bond to the vinyl ties. Please heap it on thickly. Heap it on thickly. Put the bonded area down. Place the bonded part down on top of the hair bundle and stick them together. The back side of the vinyl tie is also bonded. Attach the vinyl tie with a bundle of hair, folding it from the end and sanding it. The key is "from the ends". Attach firmly to the vinyl ties. Cut to desired length. The foundation of the aho hair, the "aho hair stick," is now ready. w Holy cow! Bond the ends of the hair. Attach the aho hair to the wig using this "aho hair stick" (*Ω*)b stick *** how to make the hair sticking out from the side *** Insert it from the outside into the gap in the side netting. Pass the "aho stick" through about two rows down. Twist the vinyl ties as you would with a bag of bread or candy. I twisted the root to stop it.　(I twisted it longer to make it easier to see.) Easy to install! I am very happy with the results. It will look like this If, on the other hand, you were to insert it from below, it would look like this If you insert it from the bottom, you can make that character of Heta-∏a. *** How to make stupid hair coming out of the cheeks or bangs *** With a cutter of the place where you want to get the stupid hairs. Make an incision between the rows of hairs. Drill a hole just large enough to allow the aho stick to pass through. Pass the aho-hair stick through the ヾ(´c_,｀*) From the back, it looks like this. I would say it's a sure thing to sew. But it is troublesome, so I staple it tightly. (Oy) Please note that the tip of the needle (spike) should be on the front of the wig. If you make a mistake and the tip of the needle comes out inside the net, it will get stuck in the net and cause a nasty sting (tsudai;*). Stapled with a staple. And then, shape the ahair and you're done!　(≧▽≦) Even after completely dry, WW can be made into various shapes. It's really easy to do. I recommend it. How to make ahog hair, part ? I'm so glad you liked it! See you soon. Cosplay General Specialty Store Classe Top