　Hello!
This time with the new color green 14.
I made a Lanka-â— in the new color green 14!
35cm wig and
40cm valance and
with a patch pin
It's so easy!
Kira☆ σ(**)
This time, the new color is green 14.
It is a deep, low gloss green. www.
Now let's get to processing!
First, I'll part the bangs.
Part the hair with a dacquard and comb the bangs with combing scissors.
I cut it down to the bone. ∀Holy shit! I'm so happy with the result!)
Netting + hair for 40 cm vance.
Remove from the valance clip.
Remove and flatten.
And then sew on the patch pins.
Any pin can be attached in any way as long as it can be secured in place.
There are six holes, but you can fasten the four corners, or just the middle...
You can fasten it in any way you like.
But please note that the comb should be oriented from top to bottom!
First, use a standard thread and needle.
even
I hate thread and needles!!!!
Here is a good news for those who say "I am not good with threads and needles!
You can also use a wire to fasten it.
From the hole at the end, you can wedge it through the hole on the other side.
Let it go through the hole one more time.
After that, twist tightly at the root.
That's a hassle too!
In this case, it is the last resort.
Ignore the hole and fix it tightly with a wire.
Left patch: wire stitch Right patch: thread stitch
I tried different ways of fastening each of them, but they all worked fine.
Now, the next step is installation.
Warp the comb of the patch pin to the opposite side. (You will hear a crackling sound☆)
Using a dacquard, clip the hair at the top of the side, letting it flow to the other side.
This is how it looks like.
Decide where to put it on.
Decide where you want to attach the patch pin.
firmly into the rows of hairs and fasten it.
Remove the dacquard and cover it with the hair that was being deflected.
Pull the elastic and shrink it to the desired size.
Brush to set.
Cut to height.
Anyway, that's about it...
Cut the back of the neck as well.
Dodge the hair at the top with a dakkar.
Place the hair firmly inside.
The center of the hair is the main area of the hair, and the entire hair is covered with fluff.
Remove the dakkar and put it on.
The left side is without the back hairs (Fukashi).
The right side is with the hairs on the reverse side.
Inverted hair on both.
Put the vinitai introduced previously in front of the top of the head.
Apply bond to the top of the head.
Attach the hair in the front.
When dry, trim the ends of the hair.
Shape the whole thing and spray harden it.
It's finished! .... *.... *...*...*...*...*...*...*...*...*... *.... *.
If it's a patch pin...
A little out of alignment, don't you think?
Even if the position is a little strange, it can be fixed with the
You can easily redo it.
Of course, you don't have to use pins.
You can also make a valance by sewing it directly onto a wig! (^-^)
therefore
I'm Lanka!
See you soon.
Cosplay General Specialty Store Classe Top
