
 Hello!
This time I'm going to show you how to make SARA into a ponytail☆
It's too silky.
I don't know if it's suitable for a ponytail...
I was also a little scared, but
I managed (laugh).
I hope I can be of help.
Also, for a neat amount of hair
It is also characterized by its low transparency.
This time we used
SARA Straight 80cm Purple 02

The color purple is quite tricky.
Depending on the camera, the color of the photo will change.
Below is an image of Purple 01 before color correction.

The colors are so different that future images will be
The following images are color-corrected to be closer to the real thing.
Left: Image without flash Right: Image with flash

Now, on to the ponytail!
By the way, how to do a ponytail using PRO.
https://classewig.com/wig/blog/?p=82
for your reference.
First, leave the hair at the fringe.
This way, it is easy to arrange the hair after tying it up.
leaving the side part of the hair on the side makes the face look smaller.

Dakkar, and distinguish them well.

Okay, now to start the ponytail!
By the way, I had to make a few attempts for this experiment.
The tips of my hair are a bit brittle.
No matter how many times I fail, it is only to the extent that the hair ends are disheveled.
SARA is amazing.

Divide the back of the head into two halves at the center.

Lift up one of the separated sides.

I'll bring it up high.

As much as possible on the inside (parting side)
Tie the knot as high as possible on the inside (parting side).

It will look something like this.

Only one side of the body is ready.

Tie both together.

Then lift both tail sections upward.

Gyuï¼ï¼ï¼ï¼
and spinning!

Let's tighten it up.

Make another half-turn.

Rubberized the rotated root part.

Tightly fasten.

It went like this!

The base of the tail section should not move.
while holding it in place with one hand.
Slowly remove the first elastic tie.

SARA has a silky hair texture.
I can easily unbutton the elastic!
Your ponytail is done!

From the back.

From the top.

Ponytail!
...
I'd like to say...
But in fact, if we don't do anything
In two hours.

ï¼ï¼ï¼ï¼ï¼ï¼
The tail is losing its energy!
By the way.
The left side is freshly made, and the right side is two hours later.


You're going to go back down to ・・・・, right? Yes, I am.
This is not just a venue.
We can't even produce the day before!
That's why
Here comes the secret weapon!
It's...

Rubber bandsï¼ï¼ï¼ï¼
Regular, rubber rubber bands.
You can tie your own hair with it.
It is very painful when you take it off.
When SARA wears a ponytail, that rubber band is a must.
For PRO, the rubber bands are the way to go.
Please be careful not to use rubber bands.
Tightly tie the root with a rubber band.

Incidentally, three rubber bands are used at once.
(This is to prevent the rubber bands from breaking, as they are a little weak.)

Hard spray on the part of the nape of the neck that sticks out.
Secure the bun with a hard spray.

SARA sprays it on.
Because the fibers are soft
The fibers are soft, so they stick to the fabrics.

The nape of the neck is complete!

This is a side view.
The lowest part of the nape of the neck is cut.

Why are we cutting it?
https://classewig.com/wig/blog/?p=82
for your reference!
From the front.
With the dakkar removed.

Since I'm here, I'm going to cut it.

Try flashing it with a ponytail.
Left, without flash Right, image with flash


The ponytail is now ready to be worn.

If you want the roots to stand up
How to make a ponytail with a standing knot ↓
https://classewig.com/wig/blog/?p=1445
for more information.
So.
That was SARA's take on how to process a ponytail!
See you soon.
Cosplay General Specialty Store Classe Top