Hello, I'm Anmuu vagina.
August is the month of events.
The peak of the heat has passed.
Summer is in its last spurt!
Be careful of heat stroke.
and capture your summer memories!
This time, we used SARA
This summer is very hot!
of the "UtaPri" characters.
Here's an introduction of how to process the characters of "UtaPri", the hottest summer show this summer.
I used SARA Short Bob-S Blue 03
At this point, which character from "UtaPri"?
If you've guessed which character from "UtaPri" at this point, you're good!
That's right, XX Seigawa! (I'm sure you can guess which character from "UtaPri" I'm talking about!)
Now, let us introduce the processing method.
First, separate the sides and bangs with a dacquard.
(See Cutting Basics and Cutting Bangs for more details.)
Cut longer bangs.
SARA has a moderate amount of hair and is very easy to cut.
Next, pat the hair on the sides.
Straighten with a comb and position the cut.
Cut to length.
Straight lines are hard to shift if you pinch them between your fingers☆.
Cutting complete!
Cut the other side in the same way.
Lift the upper half of the back with a dakkar.
Cut the lower half into a short cut.
The best length is just enough to cover the neck.
Put the top half down, too.
Cutting it down♪
Holy shit, it's short and rough!
The back hair cut took a whopping 10 minutes!
The moderate amount of hair makes SARA easy to cut. d=(´▽)=b
Now, let's see, the Seigawa style.
In the setting, the sides are in a slanted bob, so I'm going to cut a little bit more.
(If you cut too much, it will be too short, so if it looks like it will be shorter than planned, STOP here!)
Use a comb to determine the diagonal angle and cut according to the comb.
Be careful not to cut the entire comb!
(I cut about 3 teeth of the comb by this method before...)
And just like that, the diagonal cut is complete!
Next, create a parting of the hair.
Position the parting with a comb, and start from the parting and sweep it to the side.
Spray the split ends with hard spray.
Then, use a " hair brush with raised ends " to add back hairs (fukashi) at the root.
SARA is so smooth and silky that it's hard to make hair inverted or blown out (><).
Therefore, we use a "spray + brush" to blow it out finely and thoroughly.
If you still can't get it to go in, spray it and brush it again.
If you still can't get it to blow off, try heating it firmly with a hair dryer after spraying.
After the blow-drying process is complete, use a
Prepare the bangs, and cut the upper right corner of the bangs at an angle.
completion
O(≧∇≦)O
SARA is ideal for characters with silky hair.
The short bob has longer overall hair.
It is very useful when you want side length on the www.
Please give it a try!
See you soon.
Cosplay General Specialty Store Classe Top
Hello, I'm Anmuu vagina.
August is the month of events.
The peak of the heat has passed.
Summer is in its last spurt!
Be careful of heat stroke.
and capture your summer memories!
This time, we used SARA
This summer is very hot!
of the "UtaPri" characters.
Here's an introduction of how to process the characters of "UtaPri", the hottest summer show this summer.
I used SARA Short Bob-S Blue 03
At this point, which character from "UtaPri"?
If you've guessed which character from "UtaPri" at this point, you're good!
That's right, XX Seigawa! (I'm sure you can guess which character from "UtaPri" I'm talking about!)
Now, let us introduce the processing method.
First, separate the sides and bangs with a dacquard.
(See Cutting Basics and Cutting Bangs for more details.)
Cut longer bangs.
SARA has a moderate amount of hair and is very easy to cut.
Next, pat the hair on the sides.
Straighten with a comb and position the cut.
Cut to length.
Straight lines are hard to shift if you pinch them between your fingers☆.
Cutting complete!
Cut the other side in the same way.
Lift the upper half of the back with a dakkar.
Cut the lower half into a short cut.
The best length is just enough to cover the neck.
Put the top half down, too.
Cutting it down♪
Holy shit, it's short and rough!
The back hair cut took a whopping 10 minutes!
The moderate amount of hair makes SARA easy to cut. d=(´▽)=b
Now, let's see, the Seigawa style.
In the setting, the sides are in a slanted bob, so I'm going to cut a little bit more.
(If you cut too much, it will be too short, so if it looks like it will be shorter than planned, STOP here!)
Use a comb to determine the diagonal angle and cut according to the comb.
Be careful not to cut the entire comb!
(I cut about 3 teeth of the comb by this method before...)
And just like that, the diagonal cut is complete!
Next, create a parting of the hair.
Position the parting with a comb, and start from the parting and sweep it to the side.
Spray the split ends with hard spray.
Then, use a " hair brush with raised ends " to add back hairs (fukashi) at the root.
SARA is so smooth and silky that it's hard to make hair inverted or blown out (><).
Therefore, we use a "spray + brush" to blow it out finely and thoroughly.
If you still can't get it to go in, spray it and brush it again.
If you still can't get it to blow off, try heating it firmly with a hair dryer after spraying.
After the blow-drying process is complete, use a
Prepare the bangs, and cut the upper right corner of the bangs at an angle.
completion
O(≧∇≦)O
SARA is ideal for characters with silky hair.
The short bob has longer overall hair.
It is very useful when you want side length on the www.
Please give it a try!
See you soon.
Cosplay General Specialty Store Classe Top
