M-shaped one-length from the middle of the bangs

In this issue. 'The one-length method from the middle of the bangs.' We have received a question about "how to do one-length bangs from the middle of the bangs". I would like to actually do it. From the middle of the bangs to the M-shaped one-lane I don't know if you've ever seen a character with I think it's quite common. Although natural. How to make a firm "mid-M" shape? Here is a report of our experiment. This time we used Purple05 60cm. Also to be prepared is a frozen vial. I'm going to make a smaller one-liner this time. I'm using a small bottle of a nutritional drink like Yoo Kel. heh. By the way, if you want to make your one-lens bigger. There are various types of bottles, such as ribotin bottles, juice bottles, etc., so you can make them as large as you like. By the way, when you freeze them, open the caps and put them in the freezer! Water expands when frozen, so when you put it in the freezer Please do not close the cap. The bottom of the bottle is 3 cm in diameter. Drink it, feel better, kill two birds with one stone!　щ So first, part your hair in the center. The location of the M-shaped one-layer is different for each character. If you have a character with a lot of volume in the forelocks, you should place them close to the whirlpool (about 3cm from the center of the whirlpool). If you have a character with one-lane bangs, you should place them close to the whirlpool (about 3 cm from the center of the whirlpool). Create a one-lane at 5 cm to 7 cm from the nape of the neck. In this case, part the hair at 5 cm (about 1 thumb length) from the nape of the neck. The amount of hair to make the M-shape is enough, about the amount shown in the photo ☆↑ Fasten with a dacquard. On the other side, scoop the hair in the same way and secure with a dacquard. Mist with plenty of water . ::+P (**) Holly, +゜*. Remove the dakkar. Hold it in your hand, start it up, and heat it with a hair dryer. The roots should be carefully not to overheat. And here come the frozen drink bottles! Hold it firmly to the root. Let the hair fall forward as it is. Twenty seconds later, it's up and running! │*Hollywood Do the same with the other side. Chill. Bend. Now we have the foundation... ♪ But as it is, the one-liner from the middle of the road... As time goes by, it will shrivel up ○(・ω・`)Shobon....... So, we decide to put a watermark on it. It will stand up well and have the effect of making the net less visible. It is better to take a little effort here to make it look nice. First, spray lightly at the roots. Then, while holding the hair, rustle the roots and blow-dry them. Do the same for the other side. Use a fine-tooth comb for the wipe. The roots of the hair should be as upright as possible. Move the comb up and down widely at first, and then gradually move the comb finer and finer to achieve a clean look. Now you have an unbroken M-shape. I wish you the best of luck with your decision. Finally, spray to hold it in place. Cut the bangs to your desired length and you are done *:. ☆.... ... (Holy shit!) The silhouette viewed from an angle also looks natural. If you would like to add a corner to the M-section, you can do so. If you want to make a corner on the M-shaped part, you can bend it with a "coolant sandwich" when you cool it down. (See "Easy one-lane hair" at https://classewig.com/wig/blog/?p=192) If you find it difficult to decide on the position of the M-shape, you can use The safest position is about 5cm from the nape of the neck. Please try using that as a reference point. That's all for now, here's the experimental report! See you soon. Cosplay General Specialty Store Classe Top