Clean around the face! Layer cut * part 1 * cut basics

Hello everyone. My name is Aoi, and I am in charge of class styling. This time, I'd like to show you how to do a "layered cut around the face". I would like to show you how to do it. That layered cut that gradually lengthens from the top of the head to the back The layered cut that gradually lengthens from the fringe to the back! It's so cute and gives a small face effect! I want to make my wig look cute! If so, this is a must-see! That layered cut around the face that gives a great effect on a small face... Have you given up because it looks too difficult? But before you give up, check out this arrangement blog! This is actually how the layered cut is created. First of all, let me introduce the basic cutting method. Now, since this is a layered cut, we will cut from the face area. But first, let's start with the standard blocking. First, separate the part from the top of the head to behind the ears. For details of blocking for normal cutting, refer to ◆How to minimize the possibility of cutting failure For details on blocking during normal cutting, please refer to "◆How to minimize the possibility of cut failure ". The triangle from the top of the head to the corner of the eyes should be Avoid the triangle from the top of the head to the edge of the eyes as bangs. The bangs can be tied back with a dacquard or elastic, or cut in advance to keep them out of the way and out of the way. It is easier to work with the hair if it is cut in advance. It will make it easier to work with. Now, divide the area from the top of the head to behind the ears Then, divide the section from the top of the head to behind the ears vertically into 2 to 3 sections. The key to a clean cut is to not try to cut all of the hair at once. The key to a clean cut is not to cut everything at once. Divide the bundle into about this number of pieces. The bundle is divided vertically and cut separately. There are three important points to remember here! 　Point 1 ▼ The cut should be made from the area closest to the face. 　Point 2 ▼ When cutting, hair should be pulled out parallel to the floor. 　Point 3: Scissors should be cut vertically. Now, taking the above points into consideration Let's cut it! First, start with the area closest to the face. Pull out hair parallel to the floor and cut. The bangs (the part that is shorter) are cut as a guide. The reference is the area marked with a "0" in the image below. If you do not have hair to use as a guide, cut the hair closest to your face to the If you do not have any hair to use as a guide, try cutting the hair closest to your face to the length you prefer before you go. Cut the remaining parted hair using the same procedure. Cut the hair while adjusting the length so that the hair in the front is the shortest and gradually gets longer toward the back. Adjust the length of the hair as you cut it. Layer cut is complete! Compared to when only the bangs were cut, the face area was cleaned up. That's it for the basic layered cut. How was it? It may take some time at first. Once you get used to it, you will be able to do it easily. And here! I cut it, but... My hair ends are rattling...P.S." 'Straight and not in line with my face line! (-`e´-#)" Don't worry! There is a trick to make it look beautiful. It's just a matter of One step after the cut! Not only does it make the ends of the hair look beautiful, but it also makes it look more natural and more in line with the face line. it can also be made to follow the face line more naturally. For more information, please see the following article. See you again (*'omega'*)sh! Go to Cosplay General Store Classe Top