Different dimension tail made with bounce 130cm! How to make a cure star style wig
Star☆Twinkle Pretty Cure Series Part 1♪
This time I'm going to teach you how to set a wig in the Cure Star style!
SARA hair bun 130cm - S Pink 04 x2
SARA hair bun 80cm - S Pink 04 ×3
1. First, secure the ahair, the long part of the bangs, and the fringe.
For the long part of the bangs, it is recommended to keep the hair around the whirlpool. 2.
2. leave the bangs and put the wig in a twin-tail.
This time
Easy without tying up the wig! How to set the twin-tail style
(How to tie the wig in a twin-tail style).
Cut the bangs.
Cut a small amount of hair in the middle, around the ear (light blue part in the picture) in advance.
Cut a small amount of hair in the middle (the light blue part in the image) in advance and cut a round line there to make a clean line.
By cutting in portions to give you a rough idea of the length, you can prevent overcutting!
4. After cutting the bangs, curl them inward with a hair iron.
Set the hair inwards and curl the bangs, the long part of the bangs, and the fringe.
Click here to see how to make a facial hair style.
Video of how to make ahogao hair
The base wig is done!
ï¼ï¼ï¼ï¼ï¼ï¼ï¼ï¼ï¼
Now let's make the other dimensional tail!
1. [How to make aho hair easily?　Twin drills with vinyl tie process].
Make 2 bundles of wired hair (for left and right side), referring to
Leave 25cm of wire on one side of the base part.
Detailed instructions are shown in the video.
2. first avoid the hair on the surface of the valance.
Take 2 or 3 rows of inner hairs from the top, and make a reverse hair at the root.
The root of the hairs should be very well bristled, as you will be hooking wires, etc. into the bristles later on. 3.
Once the root of the hair is inverted, invert the rest of the hair and curl it inward.
　Curl inward and secure with hairpins.
When you have reached this point, sprinkle " Super Gusset Spray SGS" on the back hair. 4.
4. Repeat steps 2 and 3 to create volume up to this point.
(I haven't counted exactly, but I think I used about 12 rows.)
Repeatedly shake the spray to fix the volume.
5. thread a wire through the inverted hair you have created.
This wire will form the framework of the entire tail, so we recommend using thicker wire. 6.
6. Slightly backstitch the remaining side hairs and twist them together with the wire.
Twist the remaining side hairs together with the wire.
Twisting the wire and hairs together makes it easier to attach the hairs to the wire. 7.
7. Fix the wired hair bundle made in step 1 to the hair inverted so that it is on top of step 6. 8.
8. Cover the surface of the hair while adding hair bundles.
Paste the hairs on the wire to make the ideal line.
Use "3M Spray Glue 77" for attaching.
The surface is prepared and finished with Super Gumption Spray.
9. leaving a little bit of wire, put two bundles together with an elastic.
At this time, trim the ends of the hair as well.
10. For the Saturn (like) part at the bottom of the tail, use a hollow hemisphere.
Attach a 2-way (stretchable fabric in both directions) pink fabric to this.
The cloth I had on hand was a little darker, but I think it would be better to use a color closer to that of the hair bundle if possible.
11.10. Attach more hair bundles on top of 10.
If the cloth of the same color is attached first, it is okay even if there are gaps like this!
The weight will be lighter.
12. Make a star out of cloth and cotton, and make a hole in the center of the star.
13. Thread wires through the star, then the hemisphere, in that order.
Spread the ends of the wires and fix them with tape.
14. Make the rings of Saturn using a clear file and cloth.
Attach Saturn's rings to the hemisphere for the lower half using adhesive. 15.
15. Combine with the upper half to complete the tail section!
Attach it to the base wig and voila!
After making this wig, I realized the following
This time, the volume is too much and it is difficult to fix it with a hair clip...!
So, I decided to either keep the volume down or
I recommend removing the valance clip and replacing it with a comb pin!
Other! If you have any questions about the style, color, or processing of your wig
Please feel free to contact our staff!
Email: message@classewig.com
